1990 CHEVROLET CORVETTE 2DR COUPE
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger PPL(-) (-) STEERING COLUMN HARNESS
TrunkTrigger BLK (-) (-) AT HATCH SWITCH
HoodTrigger N/A
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK PANEL
ParkingLights BRN(+) (+) LIGHT SWITCH HARNESS
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 BRN + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AntiTheftType RESISTOR BASED SYS
AntiTheftSystem PASSKEY
KeySense LT.GRN (-) (-) IGNITION SWITCH HARNESS
NeutralSafety ORG/BLK (-) (-)
Tach WHT (-) (-) AT COIL
ParkingLights BRN(+) (+) LIGHT SWITCH HARNESS
BrakeLights WHT (+) BRAKE SWITCH ABOVE BRAKE PEDAL
ReverseLights LT.GRN (+) (+) SWITCH ON TRANSAXLE
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock BLK (REV) PASSENGER SWITCH IS MASTER SWITCH
PowerLock LT.BLU (REV) DRIVER'S KICK PANEL REVERSE POLARITY
LeftFrontWindow01 LF:DK.BLU
RightFrontWindow01 RF:GRY
LeftRearWindow01 LF:DK.BLU
Convenience
TrunkRelease BRN (+) AT SWITCH IN CONSOLE
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORN + (+) IGNITION SWITCH HARNESS
Ground BLK - (-) RADIO HARNESS
Illumination GRY (+) RADIO HARNESS
Dimmer GRY/BLK (+) RADIO HARNESS
PowerAntenna PNK (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp BEHIND PASS. SEAT
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
